Index Catalog // STAX

Start Over

Filtering by: Department, School or Faculty Advanced Forming Research Centre Qualification name sim engd

1. Life cycle and ultrasonic based non-destructive analysis of recycled and remanufactured carbon fibre reinforced plastic composite

Creator:: Paterson, David Alexander Peter
Date:: 2018
Funder:: University of Strathclyde
Department, School or Faculty:: Department of Design, Manufacturing and Engineering Management and Advanced Forming Research Centre

2. The identification of the effect of high rate deformation on the microstructure and properties of titanium alloys

Creator:: Ntovas, Michail
Date:: 2019 and 2022
Department, School or Faculty:: Department of Design, Manufacturing and Engineering Management and Advanced Forming Research Centre

3. A cost effective approach to enhance surface integrity and fatigue life of precision milled forming and forging dies

Creator:: Reimer, Andreas
Date:: 2019
Funder:: Advanced Forming Research Centre and Evans, Dorothy
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management

4. The influence of sheet conditions on the formability of titanium alloys at room temperature

Creator:: James, Kwame Sefakor
Date:: 2021
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management

5. Image processing for the analysis of TI-6AL-4V microstructures

Creator:: Campbell, Andrew
Date:: 2019
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management

6. An empirical feasibility assessment for incremental sheet forming

Creator:: Siddiqi, Muftooh Ur Rehman
Date:: 2016
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management

7. Computational generation of wear maps for H13 tool steel in open die hot forging

Creator:: Marashi, James
Date:: 2019
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management

8. Monitoring of incremental rotary forming

Creator:: Appleby, Andrew
Date:: 2019
Department, School or Faculty:: Advanced Forming Research Centre and Department of Design, Manufacturing and Engineering Management